sold

[jakazz]

ryobi 10 inch table saw w/ stand (not pictured), maybe 20 hrs on this saw. To big to be hauling from jobsite to jobsite. It has a 48" fence attached and a sliding miter table, also has spare guide plate and original with it. Saw cost over 400 new. Dewalt 105, 12" miter saw, was dropped, still cuts good, would make good siding cutoff saw, or you could send to dewalt and they could fix it for you, they are located in brighton. Craftsman 10" band saw, I dont know much about this item, was given to me by a friend. But I know it was working when he gave it to me because he bought a bigger one and just wanted to get rid of it. I'm asking for a 100.00 for the lot, picked up, no shipping. Just need to clear out the basement and have way to many tools laying around.
http://img234.imageshack.us/img234/5476/ryobisaw7tz.jpg
http://img163.imageshack.us/img163/3016/dw1057kr.jpg
http://img520.imageshack.us/img520/1528/bandsaw1eq.jpg

[If_Rider]

what exactly is wrong with the chop saw?

[jakazz]

it doesnt have the stop for 90deg. or the stop for depth, so it would cut into the table. The depth stop is fixable with a couple of screws and a longer bolt for the stop. the 90 stop is missing but is easily set with a speed square. other than that its fine, a little stiff turning the miter but other than that its fine.